WINGSTABI 12-Channel inkl. Akkuweiche 35 A - ASH 31 Tangent

[cgs]

My team: Profi TX 12 v 3.56
Rx -Multiplex WINGSTABI 12-Channel inkl. Akkuweiche 35 A
ASH 31 Tangent
Assignment of controls. Mode 2
Spoiler- E, Flaps- F, Retract gear- 5>, Pod motor- <5, Ail Brake- Assignment of switches.
DR ail-elev-rudd- 2>, Combi S- 4>, Thrott Cut- <3, Phases (vol) 1-3- <1, Phase (Vol) 4- <2
Assignment of Servos in Rx
1- Ail + 7- Ail Centr +
2- Elev + 8- Spoiler +
3- Rudd 9- Spoiler +
4- Thrott 10- Ail Brake
5- Ail + 11- Pod motor
6- Ail Centr + 12- Retract gear
Mixers, DR, Expo, not enabled.
Jumper connected.
Problem I can not program the Winstabi for this assignment of servos in the Rx
Neither with Wingstabi easy.
It does not recognize (assignment) the control for gyro phase.
Any suggestions?
I accept even memory for Tx 12 and Wingstabi
Thanks in advance.

[FrankS]

What servo channel have you assigned the gyro control to in the transmitter. The wingstabi only receives instructions sent as servo instructions.So you must assign the gyro controls to a servo output on the transmitter.

Note if you are using the non-easy firmware you have free assignment to select the input channels and the servo channels on the wingstabi. E.G aileron control could be servo 1 on the transmitter, which would then be the control input on the wingstabi,and aileron servo outputs set to 2,3,4,5,(if you have 4 ailerons).