Profi TX 3.76 Sequencer

[2m1986]

Good Morning.
I installed the new software version 3.76, and now the sequencer running fine and good.
But
- when I switch on the transmitter and the model, all the gear doors goes in OPEN position.

There is a way to disable this setting?
Or there is a way to return in CLOSE position with only 2 gear doors without made a full cycle?

I ask this because in my model I need to take off with 2 gear doors open and 2 gear door closed.

Max.

[AndreasJ]

This was the only solution for working the sequenzer with all kinds of settings....

[2m1986]

Ok, thank you for explanation.
It's a shame because all time that I have to take off.... I need to made a cycle of retracts on the ground, and the P-51 Strega weight 23Kg....

[AndreasJ]

I do not see thera a problem.... It is just working in this way for your safety....
If it would operate in an other way it could damage your doors:
e.g. if the switch is in retract in position, at powering on your airplane, when retract was already pulled out the last time.

So it is now just an additional task for you to moove the retract switch to in position and out position before you power on your model.

If you forget this procedure nothing get damaged, but it does not look like the original way......

So this is a feature MULTIPLEX have done for safety....

[2m1986]

I understand that is for safety, but the problem is:
P-51 Strega, gear doors on the wings are very big and with the KOLM thrust (propeller 32x18) I need to have it UP.
I Made first flight: during the landing I have the retracts DOWN, wings gear doors are UP, tail gear doors DOWN.
I switch OFF model, switch OFF transmitter.

Second flight I turn ON the transmitter, turn on the model.
Retracts are DOWN and all gear doors go DOWN.... at this moment I need to made one cycle of the sequencer because there is no way to take off with all gear doors DOWN. (I need the wings gear doors UP).
If I need one cycle, I have to lift 23kg of model when the retracts goes UP for completing the sequencer cycle.
Right?

[AndreasJ]

No.... You switch the model off.... Than you do the cycle in the transmitter only... Than switch on your model.... Then the second doors willbe closed.

[2m1986]

Hallo.
Ok, perfect, now I understand very well and working perfectly.

Thank You and Happy New Year.

Massimo.