Wingstabi announcement phase

[Lyngstad]

Hi, I use only phase 1,2 and 3 on my scale warbirds and use a three point stickswitch for changing between phases. This works fine but I dont know why I have to set a 2P under Servo Assign and not a 3P.
How do I get announcements on the different phases 1,2 and 3 when switching between phases?

TIP: Chrome auto translation on this topic is not good, use original text From English to english eats a lot of words...

Sincerly

Arne

[Steffen]

Hi Arne,

i need a little bit more information to help you What is your radio, which wingstabi are you using?

Sincerly
Steffen

[Lyngstad]

Profi 16 latest sw3. 55 and Wingstabi 16 latest sw.

Sincerly
Arne

[Steffen]

Hi Arne,

you need to setup wingstabi telemetry to "enhanced" and assign a msb-address for "Status Messages".
On PROFI TX you need to assign a switch for audio output on the selected msb-address

Sincerly
Steffen

[Lyngstad]

Thanks, the MSB address on my Wingstabi I have set up. But I'm not sure about the settings on my Profi Tx. A quick tip Steffen?

[Steffen]

Hi,

yes, you need to assign a switch in the sensoric-menu. You can reach this menu using the setup button (the left upper one). Im sorry - i dont know the exact english menu-texts

Steffen

[Lyngstad]

Hi, back from vacation and testing now

Again : If you have chrome auto translate everything mix up here so turn it off before reading any further.

I had done this right before like you mention above here, but there is something I do not understand. In Launcher I can see the cange between phases 1-3 when I toggle the three point switch on my stick. So far so good. If I then assign the same three switch under sensor menu to make the sound announcement the Profi only call out phase 2 and no sound when phase 1 and 3 is selected.
This is a gas plane that has a kill switch for the ignition, I have put this kill switch on a push button and if I then use this push button switch to be the sensor announchement switch everything is OK, phase 1-3 is announced when the ignition is ON, and this works for me.
Why does it not work with the the pase 1-3 switch to make the announcement directly?

Sincerly

Arne

[Steffen]

Hi Arne,

with the assigned switch in the PROFI TX you can turn announcement on/off. When turning from off to on, the announcement will be played too.
Using the same 3-way switch for phase switching and announcement is not correct. Please use another one (2way or button)

Sincerly
Steffen

[Lyngstad]

Thanks, I will use the kill sitch push button and get announcement when engine is running