Twinstar brushless setup mix throttle to rudder

[Barry]

Hello
I bought a new twinstar 2 brushless kit plus.
I have cockpit sx9 as transmitter.
I dont want to y cable the 2 esc.
I want to know how to connect it with 2 separate channels and how to use throttle to rudder mixing for sharper tunes. Can you yell me how to connect and install this?
Regards Barry

[AndreasJ]

Dear Barry,

with the built in ESC of the new Twinstar, it is not possible, since this ESC has only 1 wire.
If you want to make sharper turns, you will need 2 ESC's how to create the needed "mixer" is described in the manual Cockpit V1.20

http://www.multiplex-rc.de/Downloads/Multiplex/Bedienungsanleitungen/25160-bedienungsanleitung-cockpit-sx-7-9--de-en-fr.pdf#page=36

best regards
Andreas

[Barry]

Thanks for reply.
I have the older version 264208 kit plus.
It has 2 esc. But my screen on my sx9.has no servo mix or controller mix

[FrankS]

Have you updated your Sx9 to V1.20, the mixers were added in that update

[Barry]

I will try to do this with my local multiplex dealer.
Thanks

[FrankS]

it is easy to upgrade using Multiplex Launcher, I did my friends.

[AndreasJ]

Dear Barry,

yes, it is really easy, just give it a try!
We had described it also in the new enhanced manual V1.20

You will find the update instructions on the link below:

http://www.multiplex-rc.de/Downloads/Multiplex/Bedienungsanleitungen/25160-bedienungsanleitung-cockpit-sx-7-9--de-en-fr.pdf#page=38

The Information how to do the needed mix function for the Twinstar you will finde also there, just on an other page, check this link:

http://www.multiplex-rc.de/Downloads/Multiplex/Bedienungsanleitungen/25160-bedienungsanleitung-cockpit-sx-7-9--de-en-fr.pdf#page=36

Best regards
Andreas

[Barry]

Everything worked out ok .
Cockpit updated , took a while because we forgot to make the 1.2 sofware active in the menu after update hahaha.
But now i did according to manual the throttle to rudder mix. And put it on a switch.
I was charging the transmitter today and saw that the corona was cycling in red color and ended in steady orange. I did not have that before with the 1 version.
Sonntag morgen der erstflug.

Does it matter that the 2 regler^esc are laying on top of my receiver dr9 ? Interference?
Everybody thanks you . Vielen dank fur ihren Hilfe
Gruss Barry Leuering niederlande

[FrankS]

It is not a good idea to have the ESCs right next too the receiver, plus the ESCs will get warm in use if the heat sink is right next to the receiver it could make the receiver hot too.