Receiver LED after failsafe

[Jiihoo]

Hi,
after testing failsafe I noticed following with my
radios Royal SX16 and older Cockpit SX;

Receivers: RX-7 DR, RX-9 DR, RX-7 (all telemetry models)
Normal operationTx and Rx on : LED blinking like it should be (during one second 50% on and 50%off)

after switching Tx off: LED on (= as it should be)

switcing Tx back on : LED on for 1.5-2 sec, then off for a very short moment, on 1.5-2 sec etc.
This happens with all receivers and both Tx.
Why LED does not come back to normal operation mode ?
LQI is 100 % and servos work normally even the LED is not blinking as in normal operation.

With non-telemetry receivers:
RX-5 light and RX-7 DR light
both return to same normal operation mode after switching Tx on.

Have I missunterstood something or is that normal behaviour for telemetry receivers?

Jussi

[Michael]

Hey Jussi

That kind of blinking means, that your rx had between one and 19 signal errors.... means that is just a failure indicator!

(from the instructions)

[Jiihoo]

Hi Michael,

Okay, now I understand the 1-19 errors picture in the manual; I thought that the short block after the long (at the end) means one short flash, but it actually describes the next long block....

So it is normal, nothing to worry about ?

Br, Jussi

[Michael]

Hi

Completely normal, nothing to worry about...
It just tells you that it couldn´t get a propper signal...(means it was getting to HOLD or Failsafe)...for at least one time.

It´s pretty normal to get signal-error blinks on the rx while/after flying. you won´t notice any of them though bc they are too short anyways

[Jiihoo]

OK, alles klar, Danke