Hallo,
I have made the steps before first flight as in the manual mentioned ("Important remarks after first flight"), but every time when I start flying next time after couple of days/weeks, after switching RX on (and gyro off), aileron and elevator neutral points are not same as earlier and I have to adjust the aileron push rods in order to have same old neutral positions for ailerons and elevator.
Today when I was flying I noticed new issue;I didn't have gyro on at all and during the flight the neutral positions of the aileron servos moved so much that I had to move the radio trim to end position in order to have ailerons in the center.
Ater landing I could see easily the aileron servos were clearly not in 0-position when I changed trim back to center.
-In radio servo settings I have not changed the neutral position from 0 to anywhere.
-Wingstabi stays firmly in the plane,so it does not move inside the fuselage,
-The servo positions don't move on ground when I put all phases on from SX 12 transmitter
What have I done wrong ?
Jussi
