MPX WINGSTABI 7 How to connect?

[Jankson]

I have searched for something that shows how to connect my Futaba receiver and certainly it is strange that the only thing you can find is users who show, but on your page and all the information that is included ... there is nothing explained.
It is as if pages are missing from the manual.
It's frighteningly bad with information ....
As if you have to try it out yourself.
Why not think that it is easier to sell if there is some information?
I was disappointed that Wingstabi 7 was so big and yet lacking rescue mode.
And why should your connectors be reassembled across all other makes?
As done, to make mistakes.
I'm a bit grumpy because I also bought MPX Extra 330SC RR and frigolite in the box was stuck in the decals.
And the landing gear was crooked. (wrong drilled for one wheel) And a landing gear nut in body was missing threads.
And I also have to take out the motor to get the ESC correct under the battery.
And why not use Loctite instead of glue for the motor?
So not a good start with MPX for me.
But the only thing I want to know is where I can find out my options on my connectings... with my Futaba R7008SB Receiver?
I hope for a good start on my flight

[profimc]

Hi, Jankson!

It is a pitty that you made your start on MPX-models with a monday-made Extra. Normally MULTIPLEX-Products meet a higher level of quality.

So you have decided for a WINGSTBI 7 (WST 7) for your Extra and you run a Futaba RC. Usually it is easy to connect the receiver to the WST 7: There must be some kind of bus-signal from your receiver and the link-cable must be stuck to the bus-connector to the IN-connector on the WST 7. Pay a little attention: the minus lead of all plugs on the WST 7 must be at the top! I makes sense to stuck the powersupply to the WST 7, this could mean your ESC is stuck to it. Why so? There is only the little link-cable to the receiver and that might be too thin for powersupply on the long way.

If the WST 7 does not find the right link-version immediately you have to get the MPX-launcher (WST assitant) to work which is necessary for all the settings anyway.

By the wasy: is your WST 7 "classic" or Easy Control? I prefer the Easy Control firmware - it is easier to handle.

You miss a rescue mode on the WST 7? How do rescue modes work on other makes? Is a rescue mode anything an experienced pilot really needs? So far I haven't missed it anyway.

with regards
profimc

[Penax]

Ich habe genau das gleiche Problem Wingstabi Evolution.
Ich habe ein verstärktes Netzteil und das ist nicht der Fehler.
Verbindung konnte nicht hergestellt werden.