Copilot servo courses

[Piotr]

Hello,
I practice dual control between two MPX Profi TX.
For that I copied the memory of the model of a TX to put it in the memory of the other, via PC.
Everything works fine with the Copilot module.

However, there is still a small problem that I cannot explain to myself.
When the model is taken over by the "Student" TX the servo courses (Shift) in the model are reduced by about 40%, while the value of the servo course set in the TXs are identical, since they come from the same memory.
This can be clearly seen in the "Servo/Monitor" menu of the "Master" TX.
This is not comfortable!
Do you know a way to have an identical result with both TX

Thanks for your advices
Best regards
Piotr

[FrankS]

Piotr, the Master Tx just takes the stick positions from the student Tx, so you need to have the stick movement at 100%, if you have control rate applied on both the student and the master transmitters these get added. I.e. if you have the control rate set at 80% on both transmitters then went the student tx takes control the affected servos will move 80% of 80%, 64% of the total. Same with exponential.

[Piotr]

Hello Franks
Thank you very much for this explanation,
I will correct the Student's memory accordingly
Have a good day
Best regards
Piotr

[max_z]

Piotr, the Master Tx just takes the stick positions from the student Tx, so you need to have the stick movement at 100%, if you have control rate applied on both the student and the master transmitters these get added.

??
This is what the manual says:
Student mode
In Student mode, the control signals of the sticks and sliders are transferred via M- LINK to the teacher transmitter (without trim and travel settings).

This suggests to me that, in student mode, the signals from student to teacher are always 100%.....

Max.

[Piotr]

Hello,
Thank you all.
I started from a blank memory, without taking over the parameters of the old one. No mixing and everything at 100%.
It seems to be working fine. I have to test different models, but it seems ok
Thank you all for your advice
Have a nice day
Piotr